ADDRESS
- Email: info@printmax.me
- Website: www.printmax.me
- Contact: +973 366 39 366
Super-sized advertising that stands up to the elements.
Get your custom flags noticed, whether you’re setting them up in grass, in parking lots or even indoors.
Ground Stake Base
Steel. Included with your order.
Best for: Grass
Auger Base
9.375”-long screw digs into the ground. To order, see “Add accessories” above.
Best for: Grass, sand
Drive-over Base
Tire-friendly aluminum stabilizing base for high-traffic areas. To order, see “Add accessories” above.
Best for: Parking lots, gas stations
Pavement Base
Pour in sand or water to create a stable display on flat surfaces. To order, see “Add accessories” above.
Best for: Sidewalks, trade shows
Now you can do even more when designing your custom flags. Check out the differences between single- and double-sided printing to determine which approach is right for you.
Single-Sided Printing
Your design is printed on the front of a single piece of translucent polyester.
Double-Sided Printing
Your design is printed on the front and back of a thicker, two-layer polyester flag.
With these steps, you can set up your flag and get ready to get noticed.
1. ASSEMBLE POLE
Attach the pieces of your flag pole, and then add the antennae to the top of the pole.
2. ADD FLAG
Feed the antennae through the pocket that runs along the side of your flag.
3. ATTACH BASE
Place the prong on the top of your base into the hole at the bottom of the flag pole.
4. SECURE FLAG
Make sure the bungee is attached to both the flag and the hook on the flag pole.